Clark TK40 Tank Controller

Description

The TK40 series is the replacement of the successful Clark TK24 and loaded with features at an unbeatable price. The TK50 series is now available that will replace the TK40 series.

• Ultrasonic ESC*3 for two track motor and turret rotation
• Ultra Low turn-on resistance FET for track motor ESC
• Select a sound pack that is preloaded with the option to change the sound pack
• A TK Programmer is required to change the sound pack
  • Please note this is sold separately
• S BUS option for a quick and easy configuration
  • Only 1 wire to the receiver that offers driving and function control
  • Operation vs conventional radios is simple and similar to the HL and Taigen MFU/transmitter controls
  • Please note a compatible radio is required and the recommended FlySky FS-i6S can be purchased here
  • Please review the SBUS board radio setup guide here if you are unsure if your radio is compatible, as the configuration settings for a non-FlySky i6S can be compared against those in the user guide.
  • The end user is responsible for identification of radio compatibility when not using a FlySky i6S.
  • If an additional receiver is needed only, the FlySky FS-iA6B receiver can be purchased here
• Gun barrel stabilizer (GBS) option available
• Neutral gear
• MG2 for a 2nd MG sound and light effect option
  • Recoil solenoid supported on MG2
• Supports Tamiya IR battle format
• 22 KHz  8 bit sound, up to 5 channels of sound FX, and 3 watt output
  • Please note only an 8 ohm speaker should be used due to the load placed on the system with a 4 ohm speaker. Stock speakers are generally 4 ohms (i.e. Taigen, Torro, and Heng Long).
  • The high quality German Visaton 8 ohm FRWS 5 and FRS 7  speakers are available for purchase and sold separately.
• Smoker driver is V2 and proportional to engine RPM and load
• V2 Engine Sound Simulation
  • Multi-sample-set, frequency shift and level, and revving
• Wide operating voltage rage, from 7.2 to 12V, support 3S Li-Po battery
• Customization of some functions using IR configuration remote
  • Please note the Programming Remote and IR Configuration Line are sold separately.
• Small footprint at only 60mm X 50mm X 20mm

For full specifications, details, and programming options. Please visit the Clark TK40 page for full listing of features and specifications. To order the non-sound programmable variant of the board, please contact us.

NOTICE – THIS IS NOT 100% PLUG AND PLAY BOARD. SIMPLE CHANGES REQUIRED FOR FULL OPTIONS

Compatibility Disclaimer

• Clark Model compatibility tests are based on Mato, Tamiya, and Heng Long tanks. Accessories in the tank not listed here are not guaranteed.
• Clark Model will accept a customer sending accessories in the tank not listed here to test and fine tune if any problem occurred.